沿滑触线全长在水平与垂直平面内均不应超过10毫米,滑触线的布置与中心线的误差.滑触线相互间距离误差不应大于10毫米。

Along the sliding contact line length in horizontal and vertical plane should not be more than 10 mm, the error is arranged sliding contact line and the center line. The sliding contact line distance error should be less than 10 mm.

滑触线分段位置,测试工艺工位的布置决定供电滑触线上的扁平铜条(导线)整个区间内是分段地,每段之间用绝缘物隔开,物理的分成了通电区和断电区(非测试区),其中通电区又分为低启区(供电电压187v,制热区和制冷区(供电电压均为220v滑触线上的扁平铜条 导线 整个区间内是分段的。

Sliding contact line position, the test process of station layout decided the flat copper bar power supply sliding contact line (wire) within the entire interval is segmented, separated by insulating material between each section, the physical into electricity and power off (non test area), the ohmic region can be divided into low open area the power supply voltage (187v, business zone and the cooling zone (supply voltage are flat copper wires 220V sliding contact line within the entire interval is segmented.

先作些感性认知:铝电解多功能天车负荷继续率为65%.滑触线装置时的环境温度,作为设计难于预测,对滑触线制作、装置的平行度、水平度在国家规范的施工验收规范中无明确规定;铝电解特定环境中伸缩缝数量设置不够的情况下,运行中因检修或事故造成滑触线全线停电时有发生。

To make some perceptual cognition: aluminum electrolytic multifunctional crane load to rate of 65%. sliding contact line device when the environment temperature, as the design is difficult to predict, the sliding contact line production, equipment, level of parallelism in the code for construction and acceptance of the norms of the state without explicit provisions; condition number is not set expansion joints of aluminium electrolysis in a specific environment, operation due to maintenance or accidents caused by the sliding contact line power outages have occurred.