IEC60335 plug torque test device

In line with IEC60335-1, GB4706.1 22.3 test requirements. Compliance is determined by inserting the pin of the appliance under test into a socket without a ground contact in normal use. There is a horizontal pivot 8mm after the socket insertion surface and in the plane where these contact sleeves are located. This distance is determined by A displacement sensor A with an accuracy of at least 0.1mm. The insertion surface is kept in the vertical plane, and the torque here is tested. The test range is 0-1Nm and the accuracy is at least 0.01Nm. (The torque to hold the socket itself in the vertical plane is not included in the test value) A 50N tension can be applied to each pin in the longitudinal direction of the pin for 1min. The displacement of pins can be measured by displacement sensor A. A torque of 0.4Nm can be applied to each pin in each direction and the test time can be set to display the actual applied torque value with an accuracy of at least 0.01Nm

Comply with the standard: according to the requirements of BS1363.3 structure design and manufacturing

Application: Used to test the torque applied to the output socket by the device equipped with a pin to be inserted into the fixed output socket.

IEC60335 plug torque test device
Product features:

1, the device adopts the BS1363.3 standard structural design and manufacturing, good sensitivity, beautiful appearance.
2, due to the differences in plug standards, equipped with three types of socket fixture, can be added
3, with a level adjustment device;

1, the device adopts the BS1363.3 standard structural design and manufacturing, good sensitivity, beautiful appearance.
2, due to the differences in plug standards, equipped with three types of socket fixture, can be added
3, with a level adjustment device;

​​​​